My first run of keycap casting was a partial success, partial failure. I forgot my pointy tool to get the air out of the keycap stems so there was a big bubble instead of a stem. Other than that they formed really nicely! Some very minimal bubbles on the outer edge of the top but the form and texture look great.
Second attempt at polyurethane casting was a success! The keys are fully formed and the outsides have no bubbles.
They even fit fine on my keyboard, although one is a little looser than the other. It's clear that this resin isn't black, just a dark grey.
The working time of about 7 minutes turns out to be accurate, which is about right for the 4 moulds I have. They seemed to need the full 1 hour cure time, at the minimum demould time of 30 minutes they were a bit too flexible.
This Mastodon instance is for people interested in technology. Discussions aren't limited to technology, because tech folks shouldn't be limited to technology either!