I like the idea of making a DIY midi saxophone. Just a very basic one to make some noise

I'm guessing the hard part is measuring the breath. You could measure pressure, but if you're simulating a real sax it would have air passing straight through. I'm not sure the pressure would change much?

Hmmm

I added a basic breath sensor to the pastry saxophone. It kinda works! The response of the breath sensor is quite slow - I think I need to use something stretchier than a nitrile glove. It doesn't feel sensitive enough to do staccato notes or anything yet.

I didn't get dynamics working with the USB MIDI yet, but on/off breath control works well

The breath sensor works like this guy's video: https://www.youtube.com/watch?v=es92GqYBge0

The black tape all over it is to block out light - I found it was making a big difference to the readings.

Some quick sketches for a 3D-printed version of the mouthpiece. I can sandwich a membrane between two halves and make the whole thing a lot smaller.

The volume of air inside is smaller, and I'm hoping that means that the response to changes in pressure will be faster, enabling me to do quick staccato stuff.

Here's a first draft of the mouthpiece half - this should work ok. The other half with the sensor should be quite simple and can wait until tomorrow.

I've started printing the mouthpiece and designed the sensor half of the breath sensor. This uses a TCRT5000 IR reflectivity sensor, which shines at a diaphragm clamped between the two halves.

When you blow into the mouthpiece, the diaphragm expands towards the sensor, increasing the amount of IR that's reflected back into it.

Aaaand version 1 of the electro-sax mouthpiece is sort of assembled! It seems like it'll work but I won't be able to test it until the actual sensor arrives at the end of the week.

Electro-sax is just a way cooler name than midi sax

Dynamics now work! I'm using the breath velocity value from the cardboard breath sensor to set the MIDI breath controller value, and mapping that to volume in the synth. I'm sure there's a much more complex and nice-sounding config that can be done, but this is cool!

It needs to be a bit more linear, but that just means making some sort of calibration curve for the sensor. That can wait until I've got the 3D printed one working.

I've put the code up on https://gitlab.com/gbrnt/electro-sax

There's currently a latency problem - I need to check whether it's on the Arduino end or on the computer end. The breath sensor has some extra latency - I think that comes from the current prototype but I'm not entirely sure.

The end-to-end latency of the electro-sax is definitely too high right now. It's recommended to get it below 10ms (if you can) and here it is at 160ms.

That's enough that when you're doing something like a run of short notes you do one too many because the sound hasn't caught up yet.

Let's see how much I can improve this just by changing Jack settings. Not sure how Pipewire comes into this.

@gbrnt I'm glad I'm not the only one who still used Audacity... I was told it was outdated, but it's the only workstation that makes sense to me

@evandornbusch What do other people recommend? I haven't seen anything else for basic audio edits

@gbrnt I got a lot of recommendations for LMMS, Ardour, GarageBand, and Waveform.

@evandornbusch They all seem like they're going for a different kind of vibe to Audacity